GarrettCom 84-00136 ユーザーズマニュアル

Magnum 6K16-Series Managed Fiber Switch Installation and User Guide (04/06)

 

 

35

.

.

When the chassis top cover has been removed, the interior of the unit is 

exposed.  Looking down into the Magnum 6K16-Series unit, notice that there are 

individual PM installation spaces and female latch (white) connectors provided on the 

main board along with four stand-off’s for each 6KPM card position. (See Figure 3.6.1b) 

above. 

There are two PM slots (A, B) located on the front of the chassis cover. Looking into the 
vertical placed Chassis cover of the unit, there are three brackets with retaining screws 
(#256 flat head ) which hold each PM Face plate card slot securely. These six screws 
shown in the picture below are used to secure a PM face plate in position, but unscrew 
only four of the screws as shown in Fig. below. These screws are also used to secure the 
individual 6KPM cards screen plate which can be subjected to significant forces from the 
attached cables.  (See Figure 3.6.1c) 

Up to two front-mounted 6KPM cards may be installed in one Magnum 6K16-

Series Managed Fiber Switch unit. Follow these steps to install a 6KPM. 

Step 1.  Remove top chassis cover. See procedure in Section 3.6.1 above.  

Step 2.  Placed Granddaughter board (as shown in fig. 3.6.2a and 3.6.2b) on the chassis 

built in stand off (female) 
provided at the front of the 
6K16-Series Main Board and  

slot A & secured with three 5/16 stand-off’s 

Fig 3.6.2a Granddaughter  Board shown separately