HP (Hewlett-Packard) RPC-2 RDR ユーザーズマニュアル

30

If the status menu fails to appear, ensure the
correct cables and adapters are being used
and that they are connected properly.  Also,
verify the serial communication parameters
are correctly configured.  

To set or change the status of receptacles,
enter one of the following commands:  ON
n, OFF n, REBOOT n, where “n” is the
outlet number you want to command.
Entering an outlet number of “0” sends the
command to all outlets.

Example:

To turn “On” Outlet 3, type ON 3 from the
RPC prompt (RPC >).  The RPC responds:

Responding “Y” for yes turns “On” Outlet 3.
Observe that the status of Outlet 3 has
changed to On in the status menu:

Likewise, typing ON 0 at the RPC > prompt
and responding “Y” for yes, turns “On” all
outlets.  Typing OFF n at the RPC > prompt
turns off corresponding outlet(s).