HP (Hewlett-Packard) A3100-16-PoE v2 EI ユーザーズマニュアル
<Sysname> system-view
[Sysname] user-interface vty 1
[Sysname-ui-vty1] authentication-mode scheme
[Sysname-ui-vty1] quit
[Sysname] local-user test
[Sysname-luser-test] password cipher 12345678
[Sysname-luser-test] service-type telnet
When users telnet to the switch through VTY 1, they need to input username test and password 12345678.
After passing authentication, the users can only use level 0 commands. If the users want to use
commands level 0, 1, 2 and 3 commands, the following configuration is required:
[Sysname-luser-test] authorization-attribute level 3
Configure the user privilege level under a user interface
•
If the user interface authentication mode is scheme, and SSH publickey authentication type (only a
username is needed for this authentication type) is adopted, the user privilege level of users logging
into the user interface is the user interface level.
•
If the user interface authentication mode is none or password, the user privilege level of users
logging into the user interface is the user interface level.
Follow these steps to configure the user privilege level under a user interface (SSH publickey
authentication type):
To do…
Use the command…
Remarks
Configure the authentication type
for SSH users as publickey
for SSH users as publickey
For more information about SSH,
see the Security Configuration
see the Security Configuration
Guide.
Required if the SSH login mode is
adopted, and only username is
adopted, and only username is
needed during authentication.
After the configuration, the
After the configuration, the
authentication mode of the
corresponding user interface must
corresponding user interface must
be set to scheme.
Enter system view
system-view
—
Enter user interface view
user-interface { first-num1
[ last-num1 ] | vty first-num2
[ last-num1 ] | vty first-num2
[ last-num2 ] }
—
Configure the authentication mode
for any user that uses the current
for any user that uses the current
user interface to log in to the switch
authentication-mode scheme
Required
By default, the authentication
mode for VTY users is password,
By default, the authentication
mode for VTY users is password,
and no authentication is needed
for AUX users.
for AUX users.
Configure the privilege level for
users that log in through the current
user interface
users that log in through the current
user interface
user privilege level level
Optional
By default, the user privilege level
By default, the user privilege level
for users logged in through the
AUX user interface is 3, and that
AUX user interface is 3, and that
for users logged in through the VTY
interfaces is 0.
Follow these steps to configure the user privilege level under a user interface (none or password
authentication mode):
authentication mode):
15