HP (Hewlett-Packard) A3100-16-PoE v2 EI ユーザーズマニュアル

NMS login

NMS login overview

An NMS runs the SNMP client software. It offers a user-friendly interface to facilitate network

management. An agent is a program that resides in the device. It receives and handles requests from the

NMS. An NMS is a manager in an SNMP enabled network, whereas agents are managed by the NMS.

The NMS and agents exchange information through the SNMP protocol. The device supports multiple
NMS programs, such as iMC and CAMS.
By default, you cannot log in to the device through NMS. To enable NMS login, log in to the device via

the console port and make the configuration changes described in the following table.
The following table shows the configuration requirements of NMS login.

Object Requirements

Configure the IP address of the VLAN interface
Make sure the device and the NMS can reach each other

Device

Configure SNMP settings

NMS

Configure the NMS. For more information, see your NMS manual.

Configuring NMS login

Connect the Ethernet port of the PC to an Ethernet port of VLAN 1 of the device, as shown in

Figure 30

Make sure the PC and VLAN 1 interface can reach each other.

Figure 30 Network diagram for configuring NMS login

Follow these steps to configure SNMPv3 settings:

To do…

Use the command…

Remarks

Enter system view

system-view

—

Enable SNMP agent

snmp-agent

Optional
Disabled by default.
You can enable SNMP agent with this
command or any command that

begins with snmp-agent.

Configure an SNMP group
and specify its access right

snmp-agent group v3 group-name
[ authentication | privacy ]

[ read-view read-view ] [ write-view

write-view ] [ notify-view
notify-view ] [ acl acl-number ]

Required
By default, no SNMP group is
configured.