HP (Hewlett-Packard) A3100-8 DC EI ユーザーズマニュアル
Displaying and maintaining web login
To do…
Use the command…
Remarks
Display information about web
users
users
display web users [ | { begin | exclude |
include } regular-expression ]
include } regular-expression ]
Available in any view
Display HTTP state information
display ip http [ | { begin | exclude |
include } regular-expression ]
include } regular-expression ]
Available in any view
Display HTTPS state information
display ip https [ | { begin | exclude |
include } regular-expression ]
include } regular-expression ]
Available in any view
Web login example
HTTP login example
Network requirements
As shown in
, the PC is connected to the device over an IP network. The IP address of the Device
is 192.168.20.66/24.
Figure 27 Network diagram for configuring HTTP login
Configuration procedure
1.
Configuration on the device
# Log in to the device via the console port and configure the IP address of VLAN 1 of the device. VLAN
1 is the default VLAN.
1 is the default VLAN.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-VLAN-interface1] ip address 192.168.20.66 255.255.255.0
[Sysname-VLAN-interface1] quit
# Create a local user named admin, and set the password to admin for the user. Specify the Telnet
service type for the local user, and set the command level to 3 for this user.
service type for the local user, and set the command level to 3 for this user.
[Sysname] local-user admin
[Sysname-luser-admin] service-type telnet
[Sysname-luser-admin] authorization-attribute level 3
[Sysname-luser-admin] password simple admin
2.
Configuration on the PC
# On the PC, run the web browser. Enter the IP address of the device in the address bar, 192.168.20.66
in this example. The web login page appears, as shown in
.
70