HP (Hewlett-Packard) 2650 (J4899A/B) ユーザーズマニュアル

ページ / 306
3-14
Web and MAC Authentication for the Series 2600/2600-PWR and 2800 Switches
General Setup Procedure for Web/MAC Authentication
Additional Information for Configuring the RADIUS 
Server To Support MAC Authentication
On the RADIUS server, configure the client device authentication in the same 
way that you would any other client, except: 
Configure the client device’s (hexadecimal) MAC address as both 
username and password. Be careful to configure the switch to use the 
same format that the RADIUS server uses. Otherwise, the server will 
deny access. The switch provides four format options:
aabbccddeeff (the default format)
aabbcc-ddeeff
aa-bb-cc-dd-ee-ff
aa:bb:cc:dd:ee:ff
N o t e   o n   M A C  
A d d r e s s e s
Letters in MAC addresses must be in lowercase.
If the device is a switch or other VLAN-capable device, use the base 
MAC address assigned to the device, and not the MAC address 
assigned to the VLAN through which the device communicates with 
the authenticator switch. Note that each switch covered by this guide 
applies a single MAC address to all VLANs configured in the switch. 
Thus, for a given switch, the MAC address is the same for all VLANs 
configured on the switch. (Refer to the chapter titled “Static Virtual 
LANs (VLANs)” in the Advanced Traffic Management Guide for your 
switch.)