Benq PB2240 2000ANSI 2000:1 XGA Svideo Composite 1.9kgBrightness : 2000 99.J9377.B91 ユーザーズマニュアル

製品コード

99.J9377.B91

Introduction

Remote Control Effective Range

Infra Red (IR) remote control sensors are located on the front and the back of the projector.
The remote control must be held at an angle within 30 degrees of the projector’s IR remote
control sensors to function correctly. The distance between the remote control and the sen-
sors should not exceed 6 meters (19.5 feet).

Notes on Remote Control Operation:

Make sure that there are no obstacles between the remote control and the IR sensors on the

projector that might obstruct the infra-red beam.

Installing or Replacing the Battery

Pull out the battery holder.

Insert the new battery in the
holder.

Push the holder into the
remote control.

Avoid excessive heat and humidity.

There may be danger of an explo-

sion if the battery is incorrectly

replaced. Replace only with the

same or equivalent type recom-

mended by the manufacturer. Dis-

pose of the used battery according

to the manufacturer’s instructions.

Blank

In order to draw the audience’s full attention to the presenter, you
can use Blank to hide the screen image. Press Blank again to
restore the image. Refer to page

for more information.

Preset

According to the selected input signal, there are several picture
setup options available: Vivid mode, Presentation mode, Gaming
mode, Video mode, Cinema mode and Economic mode. Refer to
page

for more information.