HP (Hewlett-Packard) JG221A ユーザーズマニュアル

 

Device management 

Device management includes monitoring the operating status of devices and configuring their running 

parameters. 

 

 

NOTE: 

The configuration tasks in this document are order independent. You can perform these tasks in any order.

 

Configuring the device name 

A device name identifies a device in a network and works as the user view prompt at the CLI. For 

example, if the device name is Sysname, the user view prompt is <Sysname>. 
Follow these steps to configure the device name: 

To do… 

Use the command… 

Remarks 

Enter system view 

system-view 

— 

Configure the device name 

sysname sysname 

Optional 
The default device name is HP. 

 

Changing the system time 

You must synchronize your device with a trusted time source by using NTP or changing the system time 
before you run it on the network. Network management depends on an accurate system time setting, 

because the timestamps of system messages and logs use the system time.  
In a small-sized network, you can manually set the system time of each device.  

Configuration guidelines 

You can change the system time by configuring the relative time, time zone, and daylight saving time. The 

configuration result depends on their configuration order (see 

). In the first column of this table, 

1 represents the clock datetime command, 2 represents the clock timezone command, and 3 represents 

the clock summer-time command. To verify the system time setting, use the display clock command. This 

table assumes that the original system time is 2005/1/1 1:00:00.  

Table 11 System time configuration results 

 

Command 

Configuration 

example

Effective system time 

System time 

1 

date-time 

clock datetime 1:00 
2007/1/1 

01:00:00 UTC Mon 
01/01/2007 

2 

Original system time ± 
zone-offset 

clock timezone 
zone-time add 1 

02:00:00 zone-time Sat 
01/01/2005 

126