HP (Hewlett-Packard) JG221A ユーザーズマニュアル
User login control
User login control methods
The device provides the following login control methods.
Login Through
Login control methods
ACL used
Basic ACL
Advanced ACL
Telnet
Ethernet frame header ACL
NMS
Basic ACL
Web
Basic ACL
Configuring login control over Telnet users
Configuration preparation
Before configuration, determine the permitted or denied source IP addresses, source MAC addresses,
and destination IP addresses.
Configuring source IP-based login control over Telnet users
Because basic ACLs match the source IP addresses of packets, you can use basic ACLs to implement
source IP-based login control over Telnet users. Basic ACLs are numbered from 2000 to 2999. For more
source IP-based login control over Telnet users. Basic ACLs are numbered from 2000 to 2999. For more
information about ACL, see the ACL and QoS Configuration Guide.
Follow these steps to configure source IP-based login control over Telnet users:
Follow these steps to configure source IP-based login control over Telnet users:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create a basic ACL and enter its
view, or enter the view of an
existing basic ACL
existing basic ACL
acl [ ipv6 ] number acl-number
[ match-order { config | auto } ]
Required
By default, no basic ACL exists.
By default, no basic ACL exists.
Configure rules for this ACL
rule [ rule-id ] { permit | deny }
[ source { sour-addr sour-wildcard
[ source { sour-addr sour-wildcard
| any } | time-range time-name |
fragment | logging ]*
Required
Exit the basic ACL view
quit
—
78