HP (Hewlett-Packard) JG221A ユーザーズマニュアル
230 Logged in successfully
# Set the file transfer mode to binary to transmit system software image file.
[ftp] binary
200 Type set to I.
# Download the system software image file newest.bin from the PC to the device.
[ftp] get newest.bin
# Upload the configuration file config.cfg of the device to the server for backup.
[ftp] ascii
[ftp] put config.cfg back-config.cfg
227 Entering Passive Mode (10,1,1,1,4,2).
125 ASCII mode data connection already open, transfer starting for /config.cfg.
226 Transfer complete.
FTP: 3494 byte(s) sent in 5.646 second(s), 618.00 byte(s)/sec.
[ftp] bye
# Specify newest.bin as the main system software image file for next startup.
<Sysname> boot-loader file newest.bin main
# Reboot the device, and the system software image file is updated at the system reboot.
<Sysname> reboot
CAUTION:
The system software image file for next startup must be saved in the storage medium’s root directory. You
can copy or move a file to the storage medium’s root directory. For more information about the
boot-loader command, see
can copy or move a file to the storage medium’s root directory. For more information about the
boot-loader command, see
the
Fundamentals Command Reference.
Configuring the FTP server
Configuring FTP server operating parameters
The FTP server uses one of the following modes to update a file when you upload the file (use the put
command) to the FTP server:
•
In fast mode, the FTP server starts writing data to the storage medium after a file is transferred to the
memory. This prevents the existing file on the FTP server from being corrupted in the event that
anomaly, such as a power failure occurs during a file transfer.
anomaly, such as a power failure occurs during a file transfer.
•
In normal mode, the FTP server writes data to the storage medium while receiving data. This means
that any anomaly, such as a power failure during file transfer might result in file corruption on the
that any anomaly, such as a power failure during file transfer might result in file corruption on the
FTP server. This mode, however, consumes less memory space than the fast mode.
Follow these steps to configure the FTP server:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable the FTP server
ftp server enable
Required
Disabled by default.
Disabled by default.
91