HP (Hewlett-Packard) 331404-008 ユーザーズマニュアル
Configuration Menu 129
Table 138
Static ARP Configuration Menu options
Command Description
add <IP address> <MAC address>
<VLAN number> <port number>
Adds a permanent ARP entry.
del <IP address>
Deletes a permanent ARP entry.
cur
Displays current static ARP configuration.
IP Forwarding configuration
Command:
/cfg/l3/frwd
[IP Forwarding Menu]
dirbr - Enable/disable forwarding directed broadcasts
on - Globally turn IP Forwarding ON
off - Globally turn IP Forwarding OFF
cur - Display current IP Forwarding configuration
dirbr - Enable/disable forwarding directed broadcasts
on - Globally turn IP Forwarding ON
off - Globally turn IP Forwarding OFF
cur - Display current IP Forwarding configuration
The following table describes the IP Forwarding Configuration Menu options.
Table 139
IP Forwarding Configuration Menu options
Command Description
dirbr disable|enable
Enables or disables forwarding directed broadcasts. This command is disabled
by default.
by default.
on
Enables IP forwarding (routing) on the GbE2 Interconnect Switch.
off
Disables IP forwarding (routing) on the GbE2 Interconnect Switch. Forwarding
is turned off by default.
is turned off by default.
cur
Displays the current IP forwarding settings.
Network Filter configuration
Command:
/cfg/l3/nwf <1-256>
[IP Network Filter 1 Menu]
addr - IP Address
mask - IP Subnet mask
enable - Enable Network Filter
disable - Disable Network Filter
delete - Delete Network Filter
current - Display current Network Filter configuration
addr - IP Address
mask - IP Subnet mask
enable - Enable Network Filter
disable - Disable Network Filter
delete - Delete Network Filter
current - Display current Network Filter configuration
The following table describes the Network Filter Configuration Menu options.
Table 140
Network Filter Configuration Menu options
Command Description
addr <IP address>
Sets the starting IP address for this filter. The default address is 0.0.0.0
mask <IP subnet mask>
Sets the IP subnet mask that is used with
/cfg/l3/nwf/addr
to define the
range of IP addresses that will be accepted by the peer when the filter is
enabled. The default value is 0.0.0.0
enabled. The default value is 0.0.0.0
enable
Enables the Network Filter configuration.
disable
Disables the Network Filter configuration.
delete
Deletes the Network Filter configuration.
current
Displays the current the Network Filter configuration.
Route Map configuration
Command:
/cfg/l3/rmap <1-32>