HP (Hewlett-Packard) 331404-008 ユーザーズマニュアル

 

Configuration Menu  136  

 
 

OSPF Summary Range configuration  

Command:   

/cfg/l3/ospf/range <1-16>

 

[OSPF Summary Range 1  Menu] 
     addr     - Set IP address 
     mask     - Set IP mask 
     aindex   - Set area index 
     hide     - Enable/disable hide range 
     enable   - Enable range 
     disable  - Disable range 
     delete   - Delete range 
     cur      - Display current OSPF summary range configuration 

 

The following table describes the OSPF Summary Range Configuration Menu options.  

Table 149 

 OSPF Summary Range Configuration Menu options

 

Command Description 

addr <

> 

Configures the base IP address for the range.  
For example, 100.10.1.1

 

mask <

> 

Configures the IP address mask for the range. 

 

aindex <

> 

Configures the area index used by the switch.

 

hide disable|enable 

Hides the OSPF summary range.

 

enable 

Enables the OSPF summary range.

 

disable 

Disables the OSPF summary range.

 

delete 

Deletes the OSPF summary range.

 

cur 

Displays the current OSPF summary range.

 

 

OSPF Interface configuration  

Command:   

/cfg/l3/ospf/if <1-255>

 

[OSPF Interface 1  Menu] 
     aindex   - Set area index 
     prio     - Set interface router priority 
     cost     - Set interface cost 
     hello    - Set hello interval in seconds 
     dead     - Set dead interval in seconds 
     trans    - Set transit delay in seconds 
     retra    - Set retransmit interval in seconds 
     key      - Set authentication key 
     mdkey    - Set MD5 key ID 
     enable   - Enable interface 
     disable  - Disable interface 
     delete   - Delete interface 
     cur      - Display current OSPF interface configuration 

 

The following table describes the OSPF Interface Configuration Menu options.  

Table 150 

 OSPF Interface Configuration Menu options

 

Command Description 

aindex <0-2> 

Configures the OSPF area index.

 

prio <0-255> 

Configures the assigned priority value to the OSPF interfaces. 
(A priority value of 127 is the highest and 1 is the lowest. A priority value of 0 
specifies that the interface cannot be used as Designated Router (DR) or Backup 
Designated Router (BDR).)

 

cost <1-65535> 

Configures cost set for the selected path—preferred or backup. Usually the cost 
is inversely proportional to the bandwidth of the interface. Low cost indicates 
high bandwidth.

 

hello <1-65535> 

Configures the interval in seconds between the 

hello

 packets for the 

interfaces.