HP (Hewlett-Packard) 331404-008 ユーザーズマニュアル
Boot Options Menu 163
Boot Options Menu
Introduction
You must be logged in to the GbE2 Interconnect Switch as the administrator to use the Boot Options Menu.
The Boot Options Menu provides options for:
The Boot Options Menu provides options for:
•
Selecting a switch software image to be used when the GbE2 Interconnect Switch is next reset.
•
Selecting a configuration block to be used when the GbE2 Interconnect Switch is next reset.
•
Downloading or uploading a new software image to the GbE2 Interconnect Switch via FTP/TFTP.
Menu information
Command:
/boot
[Boot Options Menu]
image - Select software image to use on next boot
conf - Select config block to use on next boot
gtimg - Download new software image via FTP/TFTP
ptimg - Upload selected software image via FTP/TFTP
reset - Reset switch [WARNING: Restarts Spanning Tree]
cur - Display current boot options
conf - Select config block to use on next boot
gtimg - Download new software image via FTP/TFTP
ptimg - Upload selected software image via FTP/TFTP
reset - Reset switch [WARNING: Restarts Spanning Tree]
cur - Display current boot options
Each of the Boot Options Menu commands is discussed in greater detail in the following sections.
Updating the GbE2 Interconnect Switch software image
The GbE2 Interconnect Switch software image is the executable code running on the switch. A version of the image
ships with the GbE2 Interconnect Switch, and comes pre-installed on the device. As new versions of the image are
released, you can upgrade the software running on your GbE2 Interconnect Switch.
Upgrading the software image on your GbE2 Interconnect Switch requires the following:
Upgrading the software image on your GbE2 Interconnect Switch requires the following:
•
Loading the new image onto a FTP/TFTP server on your network
•
Downloading the new image from the FTP/TFTP server to your GbE2 Interconnect Switch
•
Selecting the new software image to be loaded into GbE2 Interconnect Switch memory the next time the switch
is reset
Downloading new software to your GbE2 Interconnect Switch
The GbE2 Interconnect Switch can store up to two different software images, called image1 and image2, as well as
boot software, called boot. When you download new software, you must specify where it should be placed: either
into image1, image2, or boot.
For example, if your active image is currently loaded into image1, you would probably load the new image software
For example, if your active image is currently loaded into image1, you would probably load the new image software
into image2. This lets you test the new software and reload the original active image (stored in image1), if needed.
To download new software to your GbE2 Interconnect Switch, you will need the following:
To download new software to your GbE2 Interconnect Switch, you will need the following:
•
The image or boot software loaded on a FTP or TFTP server on your network
•
The hostname or IP address of the FTP or TFTP server
•
The user name and password for FTP server, if necessary
•
The name of the new software image or boot file
NOTE:
The DNS parameters must be configured if specifying hostnames. See the “Domain name system
configuration” section in the “Configuration Menu” chapter.