HP (Hewlett-Packard) 331404-008 ユーザーズマニュアル

First-time configuration 18

First-time configuration

Introduction

This chapter describes how to perform first-time configuration and how to change system passwords.
To begin first-time configuration of the switch, perform the following steps.

Connect to the GbE2 Interconnect Switch console. After connecting, the login prompt displays.

HP ProLiant BL p-Class C-GbE2 Interconnect Switch A

Password:

Enter

admin

as the default administrator password.

The system displays the Main Menu with administrator privileges.

[Main Menu]
info - Information Menu
stats - Statistics Menu
cfg - Configuration Menu
oper - Operations Command Menu
boot - Boot Options Menu
maint - Maintenance Menu
diff - Show pending config changes [global command]
apply - Apply pending config changes [global command]
save - Save updated config to FLASH [global command]
revert - Revert pending or applied changes [global command]
exit - Exit [global command, always available]

>> Main#

From the Main Menu, enter the following command to access the Configuration Menu:

Main# /cfg

The Configuration Menu is displayed.

[Configuration Menu]
sys - System-wide Parameter Menu
port - Port Menu
l2 - Layer 2 Menu
l3 - Layer 3 Menu
qos - QOS Menu
acl - Access Control List Menu
rmon - RMON Menu
pmirr - Port Mirroring Menu
ufd - Uplink Failure Detection Menu
dump - Dump current configuration to script file
ptcfg - Backup current configuration to FTP/TFTP server
gtcfg - Restore current configuration from FTP/TFTP server

cur - Display current configuration

Configure Simple Network Management Protocol support

NOTE:

SNMP support is enabled by default.

Use the following command to enable SNMP:

>> # /cfg/sys/access/snmp disable|read only|read/write

Set SNMP read or write community string. By default, they are public and private respectively:

>> # /cfg/sys/ssnmp/rcomm|wcomm

When prompted, enter the proper community string.