Lindy 25032 プリント

 

 

 

 

 
 
Short Guide 

    English 

 
 

 

LINDY No. 25032  2 Port RJ-45 Gigabit 10/100/1000Base-T 

 

LINDY No. 25033  1 Port Fibre Optic Gigabit Type SC 1000Base-SX 

 

LINDY No. 25034  2 Port Fibre Optic Gigabit Type SC 1000Base-SX 

 

LINDY No. 25035  1 Port Fibre Optic Fast Ethernet Type SC 100Base-FX 

 

LINDY No. 25036  2 Port Fibre Optic Fast Ethernet Type SC 100Base-FX 

 

 
The product should contain the following items: 

o 

One module according to the LINDY part number, check from Part No. above. 

o 

This Short Guide  

 
Before you install the module in the 24+2Giga SNMP Switch, turn off the power to the switch. 
Unscrew the face plate of the module slot, this is on the front of the 24+2Giga SNMP Switch.  
Then install the module by fixing the two module screws.  Switch on the power to 24+2Giga 
SNMP switch again. 
After the Switch is powered on, it will perform “self-diagnostic” (POSD). This process takes 
about 1 min and 40 seconds to complete, during this process, the “DIAG” LED will blink green 
and the Switch will not respond to any configuration program.  All the connections to the Switch 
will not be available at this time. When the process is completed, the “DIAG” LED will stay solid 
green. 
The following table describes the meaning of each LED indicator.