Lindy 25036 プリント
Status
LED Colour
Solid Blinking
Power
Green
Power is applied to this device N/A
DIAG
Green
Self Diagnostic successful
Performing self diagnostic test
Fan 1
Red
Left cooling fan failure
N/A
Cooling
Fan 2
Red
Right cooling fan failure
N/A
Link/Act
(1 ~24 port)
(1 ~24 port)
Green
10Mbit/sec link established
TX/RX activity or collision
Green
100Mbit/sec link established
N/A
100 Mbps
(1 ~24 port)
(1 ~24 port)
OFF 10Mbit/sec
established
N/A
10/100/1000 Mbp/s RJ-45 Gigabit Port Optional Module
Bottom LED
Green
N/A
TX/RX activity or collision
Top LED
Orange 100Mbit/sec link established
when Middle LED OFF
N/A
Middle LED
Green
10Mbit/sec link established
when Top LED OFF
when Top LED OFF
N/A
Top & Middle
LEDs
LEDs
Orange
& Green
& Green
1000Mbit/sec link established
when both LED’s ON
when both LED’s ON
N/A
FCC Compliance Statement (United States)
This equipment generates, uses and can radiate radio frequency energy and if not installed and
used properly, that is, in strict accordance with the manufacturer’s instructions, may cause
interference to radio communication.
It has been tested and found to comply with the limits for a class A computing device in
accordance with the specifications in Subpart B of part 15 of FCC rules, which are designed to
provide reasonable protection against such interference when the equipment is operated in a
commercial environment. Operation of this equipment in a residential area may cause
interference, in which case the user at his own expense will be required to take whatever
measures may be necessary to correct the interference.
Changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
Canadian Department of Communications RFI statement
This equipment does not exceed the class A limits for radio noise emissions from digital
apparatus set out in the radio interference regulations of the Canadian Department of
Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe A prescrites dans le règlement sur le
brouillage radioélectriques publié par le ministère des Communications du Canada
This equipment generates, uses and can radiate radio frequency energy and if not installed and
used properly, that is, in strict accordance with the manufacturer’s instructions, may cause
interference to radio communication.
It has been tested and found to comply with the limits for a class A computing device in
accordance with the specifications in Subpart B of part 15 of FCC rules, which are designed to
provide reasonable protection against such interference when the equipment is operated in a
commercial environment. Operation of this equipment in a residential area may cause
interference, in which case the user at his own expense will be required to take whatever
measures may be necessary to correct the interference.
Changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
Canadian Department of Communications RFI statement
This equipment does not exceed the class A limits for radio noise emissions from digital
apparatus set out in the radio interference regulations of the Canadian Department of
Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe A prescrites dans le règlement sur le
brouillage radioélectriques publié par le ministère des Communications du Canada
Tested to comply
with FCC Standards LINDY No. 25030 , 25032, 25033, 25034, 25035, 25036
with FCC Standards LINDY No. 25030 , 25032, 25033, 25034, 25035, 25036