Black Box LEH8814 ユーザーズマニュアル

 

Radius Configuration, Port-Based Authentication 
 
Radius Configuration 
Radius Status: 
1. 

Command Mode: Configure mode 

Logon to Configure Mode (Config
The switch_a(config)# prompt will show 

switch_a(config)# 

ure Terminal Mode). 

on the screen. 

 
2. Usage: 
Use dot1x system-auth-ctrl command to globally enable authentication. 
Use no dot1x system-auth-ctrl

 authentication. 

 
3. Command 

Syntax: 

(no) dot1x system-auth-ctrl 
 
4. Example: 
The following example globally enables authentication: 

switch_a(config)#dot1x system-auth-ctrl 
switch_a(config)# 

 command to globally disable

 

 

 
Radius Server IP: 
Radius Server Port: 
1. 

Command Mode: Configure mode 

Logon to Configure Mode (Configure Terminal Mode). 
The switch_a(config)# prompt will show on the screen. 

switch_a(config)# 

 
2. Usage: 
Use this command to specify the IP address of the remote radius server host 
and assign authentication and accounting destination port number. 
 
3. Command 

Syntax: 

(no) radius-server host IP-ADDRESS auth-port PORT 

IP-ADDRESS A.B.C.D specifies the IP address of the radius server host. 
PORT specifies the UDP destination port for authentication requests. The 
host is not used for authentication if set to 0. 

 
4. Example: 
The following example specifies the IP address (192.168.1.100) of the 
remote radius server host and assigns authentication and accounting 
destination port number (1812):