Linksys SGE2000 ユーザーズマニュアル

Chapter

The Ethernet switch can be reset by inserting a pin or paper clip into the RESET opening. If 
the reset switch is held for 10 seconds or longer, the Ethernet switch will be reset to its default 
settings.

When a unit is reset to its default setting, the unit restarts in stackable mode using default 
stacking ports with autonumbering enabled. Pressing the reset button on the master unit of a 
stack resets all units in the stack.

The Ethernet switch is equipped with 24 Ethernet ports.

All user-defined settings are 

lost when you hold the Reset button for 
10 seconds or longer; the Ethernet 
switch reverts to its default settings.

1-24

The Switch is equipped with 24 auto-sensing, Ethernet (IEEE 802.3) 
network ports, which use RJ-45 connectors. The Gigabit Ethernet ports 
support network speeds of 10Mbps, 100Mbps, and 1000Mbps. They 
can operate in half and full-duplex modes. Auto-sensing technology 
enables each port to automatically detect the speed of the device 
connected to it, and adjust its speed and duplex accordingly.

In stacking mode, two ports are used for stacking. By default, the 
stacking ports are 12 and 24.

Ports 11, 12, 23, and 24 are shared with GBIC1, GBIC3, GBIC2, 
GBIC4 respectively. If shared port pairs are both connected, then the 
mini-GBIC port takes priority.