Motorola P880 ユーザーズマニュアル

Cajun P880 Routing Switch Installation Guide 

1 - 5

2. Lay out the static-dissipative work surface.

3. Connect the ground cord assembly to the ESD mat and to the 

ground plug on the front fan tray. This takes a standard banana 
jack or a #10-32 screw.

4. Wear the ESD wrist strap and attach it to the ground cord 

assembly.

* Note:  The screws and nuts needed to attach the shelf to the 

rack are not supplied. It is recommended you use, at 
least, a quantity of three #10 pan head screws for 
installation.

There are three brackets supplied for the shelf installation: shelf 
pieces and one brace for the rear of the rack. To install the shelf:

1. Install the mounting shelf. Attach the two side shelf pieces to the 

rack. Make sure that each hole on the mounting bracket lines up 
with a hole on the rail. This ensures proper vertical placement in 
the rack. Do 

not completely tighten the screws.

2. Attach the brace piece to the shelf pieces by inserting the 

attached stud into the holes on the shelf pieces and tightening 
the nuts (Figure 2).

3. Check the rack and shelf to ensure they are square before 

installing the chassis. 

Tighten all screws before installing the 

chassis.