Intel 5800/120Ld ユーザーズマニュアル

1.  Power off the system and ensure it is disconnected from the AC power

source.

2.  Open the front door and remove the left side panel as described earlier in

this chapter.

Observe static precautions. Use an antistatic wrist strap.
Hold the processor only by its edges.

3.   If your system has one processor and you are adding a second processor,

then you must remove the termination board in the Slot 1 secondary
connector and store it appropriately.

4.  If your system has one processor and you are replacing it, leave the

terminator board intact in the empty secondary processor connector. Remove
the processor you want to replace.

5.  If your system has two processors and you are replacing one or both, remove

the appropriate one(s).

6.  Pull the processor latches, (Figure 4-7,A) out away from the edges of the

SECC2 cartridge to free them from the Universal Retention Module (URM).

7.  Lift the SECC2 cartridge upward, out of the URM and place it on a

grounded, static-free surface or conductive foam pad.

8.  Put the old processor in a piece of conductive foam and store in an antistatic

package.

9.  Remove the new processor from its antistatic package and place

it on a grounded, static-free surface or conductive foam pad.