Intel 5800/120Ld ユーザーズマニュアル

13. If you are removing a hard disk drive, remove the four screws securing the

drive to the drive bay. See Figure 4-22.

14. Position the drive bay in the chassis and slide the tab located on the right

side of the drive bay into the slot in the right side of the chassis.

15. Secure the drive bay to the chassis with the two front mounting screws

removed in Step 6. See Figure 4-20, C and D.

16. Install the mounting screws that secure the drive bay to the right side of the

chassis. See Figure 4-20, A and B.

17. Install the mounting screw that secures the drive bay to the left side of the

chassis. See Figure 4-20, E.

18. Connect all interface cables and voltage cables to all drives in the drive bay.

19. Install the left and right side panels as described earlier in this chapter.

20. If open, close the EMI metal panel in front of the hard drive cage and secure

by turning its two thumb lock screws clockwise.

21. Close and secure the front door.

22. Connect the system to its AC source and power up.