HP (Hewlett-Packard) DL100 Series ユーザーズマニュアル
4.
Install the hard drive.
Installing a non-hot-plug hard drive
The server supports up to two SATA hard drives with the embedded controller.
The server supports up to two SAS or two SATA hard drives with the following options:
The server supports up to two SAS or two SATA hard drives with the following options:
•
Optional SAS controller
•
Optional SAS controller cable
•
Optional SAS hard drive LED cable ("SAS hard drive LED cable option" on page 35) (for LED
functionality)
functionality)
For optimal performance, do not mix SAS and SATA hard drives.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
IMPORTANT:
If only one hard drive is installed, install it in the bay with the lowest device
number. For drive installation guidelines, refer to "SAS and SATA hard drive guidelines (on
To install the component:
1.
Power down the server (on page 13).
2.
Remove the server from the rack (on page 13).
3.
Remove the access panel (on page 14).
Hardware options installation 27