HP (Hewlett-Packard) L700 (CTL700) ユーザーズマニュアル

Connecting the Fibre Channel Components for the 
CTL700 Tape Library

L700 (CTL700) Installation and User’s Guide — 527338-004

Powering on the Tape Drive and the Fibre Channel

Converter

After you have installed the fiber cable, power on both the CT9840FC-1 tape 
drive and the CT9800FC Fiber Channel converter. The CT9840FC-
1/CT9841FC-1 tape drive must be powered on first.

1. Make sure that the power cords are fully seated into the AC power 

receptacles on both the tape drive and the Fibre Channel converter.

2. Attach the male end of the power cords to two separate power outlets.

3. Press the power switch to 1 on

 the CT9840FC-1/CT9841FC-1 tape drive.

4. Press the power switch to 1 on

 the CT9800FC Fiber Channel converter.

5. Verify that both of the devices power on.

If connectivity is not established, the FC green LED will not be illuminated on the 
converter as shown in 

. You will need to check the fiber cable 

connections on both the tape drive and the Fibre Channel converter.

The CT9840FC-1/CT9841FC-1 tape drive must be powered on first.

The CT9840FC-1/CT9841FC-1 tape drive and the CT9800FC Fibre Channel 

converter do not have protection against lightning surges. For this reason, those customers 
located in high risk areas should use external surge protection rated for use in their location 
and be able to handle the power demand of the  Fibre Channel converter enclosure.