HP (Hewlett-Packard) L700 (CTL700) ユーザーズマニュアル

Connecting the Fibre Channel Components for the 
CTL700 Tape Library

L700 (CTL700) Installation and User’s Guide — 527338-004

Powering on the CTL700 Tape Library and the Fibre

Channel Converter

After you have installed the fiber cable, power on both the CTL700 tape library 
and the CT9800FC Fibre Channel converter. The tape library must be powered 
on first.

1. Check that the power cords are fully seated into the AC power receptacles 

on both the tape library and the Fibre Channel converter.

2. Attach the male end of the power cords to two separate power outlets.

3. Press the power switch to 1 “on position” on the CTL700 tape library.

4. Press the power switch to 1 “on position” on the CT9800FC Fibre Channel 

converter.

5. Verify that both of the devices power on.

If connectivity is not established, the FC green LED will not be illuminated as 
shown in 

 on page A-11. You will need to check the fiber cable 

connections on both the tape drive and the Fibre Channel converter.

Remember that the CTL700 tape library must be powered on first.

The CT9800FC Fibre Channel converter and the CTL700 tape library does not 

have protection against lightning surges. For this reason, those customers located in high risk 
areas should use external surge protection rated for use in their location and be able to handle 
the power demand of the converter enclosure.