HP (Hewlett-Packard) DL185 ユーザーズマニュアル

 

 

Contents 67   

 

 

System Fan  

The server has four system fans located on the chassis’ center wall. 
The figure below identifies the system fans by their device number and shows their corresponding 

cable connections. 

Figure 62 System fan connections 

 

Device number 

Connector 

System fan 1 

P12 on the system board 

System fan 2 

P18 on the system board 

System fan 3 

P13 on the system board 

System fan 4 

P19 on the system board 

System fans 1 to 3 are for the memory modules and processors, while system fan 4 is for the PCI slots and 

system chipsets. 

A new system fan can be installed to allow the server to operate properly in case a default system fan 

becomes defective. 
To remove the system fan:  

1. 

Disconnect the fan cable from its corresponding board connector. 

2. 

Release the fan cable from the cable clip securing it to the chassis partition wall. 

3. 

Squeeze the release tab on the system fan to release it from the chassis. 

4. 

Lift the system fan away from the chassis.