HP (Hewlett-Packard) AW522A ユーザーズマニュアル
Unit identification (UID) button
The unit identification (UID) button helps locate an enclosure and its components. When the UID button
is activated, the UID on the front and rear of the enclosure are illuminated.
is activated, the UID on the front and rear of the enclosure are illuminated.
NOTE:
A remote session from the management utility can also illuminate the UID.
•
To turn on the UID light, press the UID button. The UID light on the front and the rear of the enclosure
will illuminate solid blue. (The UID on cascaded storage enclosures are not illuminated.)
will illuminate solid blue. (The UID on cascaded storage enclosures are not illuminated.)
•
To turn off an illuminated UID light, press the UID button. The UID light on the front and the rear
of the enclosure will turn off.
of the enclosure will turn off.
Power on/standby button
The power on/standby button applies either full or partial power to the enclosure chassis.
•
To initially power on the enclosure, press and hold the on/standby button for a few seconds, until
the LEDs begin to illuminate.
the LEDs begin to illuminate.
•
To place an enclosure in standby, press and hold the on standby button for a few seconds, until
the on/standby LED changes to amber.
the on/standby LED changes to amber.
NOTE:
System power to the disk enclosure does not completely shut off with the power on/standby button.
The standby position removes power from most of the electronics and components, but portions of
the power supply and some internal circuitry remain active. To completely remove power from the
system, disconnect all power cords from the device.
The standby position removes power from most of the electronics and components, but portions of
the power supply and some internal circuitry remain active. To completely remove power from the
system, disconnect all power cords from the device.
SAS cables
These disk enclosures use cables with mini-SAS connectors for connections to the host and to additional
cascaded disk enclosures.
cascaded disk enclosures.
Use supported SAS cables with mini-SAS connectors. A variety of SAS cables and cable lengths are
supported for use with this disk enclosure. For more information, see the QuickSpecs for the disk
enclosure, available on the D2000 website:
supported for use with this disk enclosure. For more information, see the QuickSpecs for the disk
enclosure, available on the D2000 website:
.
D2600/D2700 Disk Enclosure User Guide
17