HP (Hewlett-Packard) A9834-9001B ユーザーズマニュアル
Chapter 3
Installing the System
Booting and Verifying the System
125
Figure 3-44 MP Virtual Front Panel
Step 6. From the VFP menu, enter s to select the whole system, or enter the partition number to select a
particular partition. An output similar to that shown in Figure 3-45 appears. In this example, no
status is listed because the system 48 V has not been switched on.
status is listed because the system 48 V has not been switched on.
Figure 3-45 Example of Partition State—Cabinet Not Powered Up
Step 7. For each of the remaining windows, bring up the partition console for each partition by enter co at
the MP> prompt, as shown in Figure 3-46. These windows should be blank. If not, the information
in them means nothing at this point because the cabinet is powered off.
in them means nothing at this point because the cabinet is powered off.