HP (Hewlett-Packard) BL465C ユーザーズマニュアル

 

Operations 14 

Remove the access panel 

To remove the component: 

1. 

Power down the server blade (on page 

2. 

Remove the server blade (on page 

3. 

Lift the access panel latch and slide the access panel to the rear. 

4. 

Remove the access panel. 

  

 

WARNING:

  To reduce the risk of personal injury from hot surfaces, allow the drives and the 

internal system components to cool before touching them. 

  

  

 

CAUTION:

  To prevent damage to electrical components, properly ground the server blade 

before beginning any installation procedure. Improper grounding can cause ESD. 

  

 

Install the access panel 

1. 

Place the access panel on top of the server blade with the hood latch open. Allow the panel to 
extend past the rear of the server blade approximately 0.8 cm (0.2 in). 

2. 

Engage the anchoring pin with the corresponding hole in the latch. 

3. 

Push down on the hood latch. The access panel slides to a closed position.