HP (Hewlett-Packard) tc2100 ユーザーズマニュアル

87 

5.  Holding the DIMM at 90 degrees to the system board, press the DIMM fully into the slot until the 

retaining latches close.  

If the latches do not close, the DIMM is not inserted correctly. 

6.  Repeat Steps 1-5, to install all of the remaining DIMMs for your memory configuration. 

7.  Replace the left side cover. 

8.  Replace the external cables and power cord. 

9.  Power on the Server, as described in Chapter 2, “Controls, Ports, and Indicators.” 

If the DIMMs are not seated properly you may get a blank screen. 

Most DIMMs are dimensionally identical, so, if you have two or more DIMMs installed, 
you may verify all DIMMs are seated by sliding a straight edge (a pen, for example) 
across the top edges and verify it remains in continuous contact with all of the DIMMs. 

The procedures listed here for removing and replacing a processor and its heatsink-cooling fan are the same 
for all of the processors used in this HP Server. 

 

Wear a wrist-strap and use a static-dissipating work surface connected to the chassis 
when handling components. Ensure the metal of the wrist-strap contacts your skin. 

1.  If the Server is operating, power down the Server.  

Refer to Chapter 2, “Controls, Ports, and Indicators” for instructions. 

2.  Disconnect the power cord and any external cables connected to the Server.  

If necessary, label each one to expedite re-assembly. 

3.  Remove the left side cover.