HP (Hewlett-Packard) RP4410 ユーザーズマニュアル

Removing and Replacing Components

Upgrade tasks depend on whether the server is configured for simplex or duplex operation. The following 
information provides the high-level steps required to perform the upgrade. The actual upgrade procedures are 
provided below.

1. Back up your data

2. Shutdown the server (disconnect ac power)

3. Remove server components

4. Replace SCSI backplane

5. Install server components

6. Verify the upgrade installation

1. Back up your data

2. Shutdown the server (disconnect ac power)

3. Remove server components

4. Remove the SCSI duplex board

5. Replace SCSI backplane

6. Install the replacement SCSI duplex board

7. Install server components

8. Verify the upgrade installation

Before performing the server upgrade, protect yourself by backing up all data and the server OS. In the event 
of interruptions (for example, power failure or interference), you may need to resume operation in the old 
configuration before upgrading the server.

Back up your data in accordance with local procedures.

Always keep a backup copy of the current OS available for emergency use. The OS was provided on CD with 
the server. You can obtain a copy from your HP-Information Resource Center (ITRC).