HP (Hewlett-Packard) RP4410 ユーザーズマニュアル
Chapter 6
Removing and Replacing Components
SCSI Backplane
252
If you will not be installing a hot-pluggable disk drive in slot 2, you must install a volume filler.
Figure 6-49
Volume Filler Installation in Slot 2
SCSI Backplane
The SCSI backplane is attached to the rear of the disk media housing at the front right side of the chassis.
WARNING
Ensure that the system is powered off and all power sources have been disconnected
from the server before removing or replacing the SCSI backplane.
from the server before removing or replacing the SCSI backplane.
Voltages are present at various locations within the server whenever an ac power
source is connected. This voltage is present even when the main power switch is in
the off position.
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning can result in personal injury or damage to
equipment.
equipment.
CAUTION
Failure to properly complete the steps in this procedure results in erratic system behavior or
system failure. For assistance with this procedure contact your local HP Authorized Service
Provider.
system failure. For assistance with this procedure contact your local HP Authorized Service
Provider.
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions can result in damage to the server.
safety precautions can result in damage to the server.