HP (Hewlett-Packard) RP4410 ユーザーズマニュアル

Removing and Replacing Components

To replace the power distribution board, follow these steps:

Step 1. Replace the power distribution board over the keyway slots and push it towards the side of the 

chassis to lock it onto the studs.

Step 2. Reattach the power distribution board to the chassis bulkhead by replacing the one T-15 screw and 

hand tightening it.

Step 3. Replug the power and signal cables into the midplane riser board.

Step 4. Replace the hot-swappable power supplies into the chassis. (See “Replacing a Hot-Swappable Power 

Supply” on page 260.)

Step 5. Replace the power supply fan unit into the chassis. (See “Replacing a Hot-Swappable Chassis Fan 

Unit” on page 206.)

Step 6. Replace the top cover. (See “Replacing the Top Cover” on page 183.)

Power Distribution Board

Attaching 
Screw Hole