HP (Hewlett-Packard) RP4410 ユーザーズマニュアル
Installing the System
Installing Additional Components
Chapter 3
81
System Battery
This section provides information on the system battery and how to replace a system battery.
Battery Notice
This product contains a Lithium battery.
WARNING
Lithium batteries can explode if mistreated. Do not recharge, disassemble, or
dispose of lithium batteries in a fire. Failure to observe this warning can result in
personal injury or damage to equipment.
dispose of lithium batteries in a fire. Failure to observe this warning can result in
personal injury or damage to equipment.
Replace with the identical or equivalent battery. Follow the manufacturer’s recommendations. Dispose of used
batteries according to the manufacturer's instructions.
batteries according to the manufacturer's instructions.
Replacing the System Battery
CAUTION
Before replacing the system battery, record all boot configuration settings listed by the BCH
INFO ALL
INFO ALL
command. These values must be reset after replacing a battery.
To remove and replace the system battery, follow these steps:
Step 1. If rack-mounted, slide the server out from the rack until it stops. (See “Extend the Server from the
Step 2. Remove the top cover from the chassis. (See “Removing the Top Cover” on page 73.)
Step 3. Remove the I/O baseboard assembly from the chassis. (See “Removing the I/O Baseboard Assembly”
Step 4. Locate the system battery on the I/O baseboard.