Fujitsu N800 ユーザーズマニュアル

46

 

 U41243-J-Z156-1-76

Configuration software and utilities

Ê

Press 

[F2]

 to start 

 and configure the settings.

If you do not press 

[F2]

, the boot process continues and the following 

message is displayed:

Press 

[Alt]

 + 

[Q]

 to enter SCSI Utility

I

If you do not press 

[F2]

 and do not have a hard disk drive with an 

operating system installed or a CD with the operating system in the 
CD-ROM drive, this message remains on the screen for a few 
seconds while the boot process continues, and the system beeps 
once. Then the following message is displayed:

Operating System not found

In this case, install the operating system first.

Ê

Press the key combination

[Ctrl]

 + 

[C]

 to call the SCSI utility (only if SCSI 

devices are installed). Follow the instructions displayed on the screen to 
configure the onboard SCSI host adapter and to run the SCSI utilities (see 
also the section “QLogic SCSI utility” on page 72). 

If you do not call the SCSI utility, the boot process continues.

Ê

Press 

[Esc]

 during POST to access a boot menu when POST has finished. 

You can choose the boot device or start 

 from this menu.

The system emits a beep to indicate that POST has been completed.

What appears next on your screen depends on whether an operating system is 
installed on your server and which operating system is involved.

If the system stops before the POST has been completed, it emits a beep code 
to indicate a critical system error that requires immediate attention. If POST 
messages are displayed on the screen, the system beeps twice when the 
message appears.

Take note of the messages displayed and write down the beep code you hear 
since this information is useful to your service representative. You will find a list 
of the beep codes generated by POST and error message in the chapter 
“Troubleshooting and tips” on page 75.