Fujitsu MX130 S2 ユーザーズマニュアル
212
Upgrade and Maintenance Manual
MX130
S2
System board and components
Ê
Carefully loosen the TPM screw using a thin slotted screw driver (e.g.
watchmaker's screw driver) or the dedicated TPM screw driver (Japanese
market) (2).
watchmaker's screw driver) or the dedicated TPM screw driver (Japanese
market) (2).
V
CAUTION!
Ensure to turn the screw in the direction of the arrow in order to
remove it!
remove it!
Slowly and carefully increase the pressure on the screw until it begins
to turn. The effort when loosing the screw should be as low as
possible.
to turn. The effort when loosing the screw should be as low as
possible.
Otherwise the thin metal bar may break, rendering it impossible to
loosen the screw.
loosen the screw.
Ê
Remove the TPM screw (3).
Ê
Remove the defective TPM board on the upper side of the system board.
Figure 134: Removing the TPM spacer
Ê
Using a small pair of combination pliers, press together the hooks on the
TPM spacer (1, see circle) and remove it from the system board (2).
TPM spacer (1, see circle) and remove it from the system board (2).
I
If the TPM module is to be replaced, the TPM spacer may remain on
the system board.
the system board.
12.2.2.4 Concluding steps
Perform the following procedures to complete the task:
Ê
Follow all procedures described in section