Fujitsu MX130 S2 ユーザーズマニュアル
120
Upgrade and Maintenance Manual
MX130
S2
HDDs and accessible drives
Figure 57: Removing HH ODD
Ê
Push the green handle backward (1) and pull the half-height ODD out of the
bay (2).
bay (2).
Ê
Disconnect the fixation plate from the HH ODD cage.
V
CAUTION!
Always replace dummy modules into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
applicable EMC regulations and satisfy cooling requirements.
7.14.4 Concluding steps
Perform the following procedures to complete the task:
Ê
Install the 5.25-inch dummy cover as described in section
.
Ê
Follow all procedures described in section
Ê
If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
maintenance task, re-enable BitLocker as described in section
/
0