Lucent Technologies lucent ユーザーズマニュアル
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-875
M/T-BD (Maintenance/Test Circuit Pack)
10
M/T-BD (Maintenance/Test Circuit
Pack)
Pack)
!
CAUTION:
In G3iV1.1-286 and G3iV2-386, a TN771D (or later vintage)
Maintenance/Test circuit pack must be used.
Maintenance/Test circuit pack must be used.
Refer to XXX-BD (Common Port Circuit Pack) Maintenance documentation for
circuit pack level errors. See also M/T-DIG (Maintenance/Test Digital Port) and
M/T-PKT (Maintenance/Test Packet Bus Port) Maintenance documentation for
related digital port and Packet Bus port information, respectively.
circuit pack level errors. See also M/T-DIG (Maintenance/Test Digital Port) and
M/T-PKT (Maintenance/Test Packet Bus Port) Maintenance documentation for
related digital port and Packet Bus port information, respectively.
1.
Where P is the port network number (1 for PPN and 2 or 3 for EPN); C is the carrier designation
(for example, A, B, C, D, or E); and SS is the address of the slot in the carrier where the circuit
pack is located (for example, 01, 02, ..., etc.).
(for example, A, B, C, D, or E); and SS is the address of the slot in the carrier where the circuit
pack is located (for example, 01, 02, ..., etc.).
MO Name (in
Alarm Log)
Alarm
Level
Initial Command to Run
1
Full Name of MO
M/T-BD
MIN
test board PCSS l
Maintenance Test Circuit Pack
M/T-BD
WRN
release board PCSS
Maintenance/Test Circuit Pack