Lucent Technologies lucent ユーザーズマニュアル

Issue 1

August 1997

Error Messages 

Page A-63

release tdm 

If the station port resides on a board that is part of the SCI link, the following message 
will be displayed:

Cannot busyout/release part of SCI link

If the command entered is in conflict with another currently executing command, then a 
message will be displayed showing the login id of the conflicting user and the conflicting 
command. The message is as follows:

’login id’:’command’ has a command conflict

If during the execution of a command a resource problem occurs that requires the user 
to restart the command, then the following message will be displayed:

Command resources busy; 

Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the following 
message will be displayed:

All maintenance resources busy; try again later

If the system technician presses 

HELP

 after entering "release tdm," the following message 

will be displayed:

Enter ’port-network’, port network number (1-3),

 ’bus’, bus (’a’ or ’b’)

If the technician enters "bus" before "port-network," the following message will be 
displayed:

’bus’ is an invalid identifier; please press 

HELP

If the technician does not enter all digits for the port-network number, the following 
message will be displayed:

Entry must be all digits

If the technician enters a bus other than A or B, the following message will be displayed:

Identifier invalid

If the technician enters a TDM bus identifier with a Port Network number that is not 
administered, the following message will be displayed:

Port Network number not assigned