Lucent Technologies lucent ユーザーズマニュアル

Issue 1

August 1997

Error Messages 

Page A-129

test network-control 

If the command entered is in conflict with another currently executing command, then a 
message will be displayed showing the login id of the conflicting user and the conflicting 
command. The message is as follows:

’login id’:’command’ has a command conflict

If during the execution of a command a resource problem occurs that requires the user 
to restart the command, then the following message will be displayed:

Command resources busy;

Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the following 
message will be displayed:

All maintenance resources busy; try again later

If the system technician presses 

HELP

 after entering "test network-control" the following 

message will be displayed for a simplex switch configuration:

Enter [’long’ or ’short’], [’repeat’ (1-100)

or ’clear’], [’schedule’]

For a duplex switch configuration, the following message will be displayed:

Enter [cabinet(1)];carrier(A-B),

[’long’ or ’short’], [’repeat’ (1-100)

or ’clear’], [’schedule’]

If the SPE is not active, the following message will be displayed:

Command must be executed from active SPE

If the carrier entered is invalid, the following message will be displayed:

"entered value" is an invalid identifier; 

press RETURN to execute modified command

If the NETCON board is not TN777B, the following message will be displayed:

Must install TN777B circuit pack

If the entered standby carrier cannot be retrieved, the following message will be 
displayed:

Error encountered, can’t complete request

If there aren’t any tests found for this MO, the following message will be displayed: