Lucent Technologies lucent ユーザーズマニュアル

Issue 1

August 1997

Error Messages 

Page A-136

test shadow-link 

Standby SPE not available;

for information use ’status system’

If the command entered is in conflict with another currently executing command, then a 
message will be displayed showing the login id of the conflicting user and the conflicting 
command. The message is as follows:

’login id’:’command’ has a command conflict

If during the execution of a command a resource problem occurs that requires the user 
to restart the command, then the following message will be displayed:

Command resources busy;

Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the following 
message will be displayed:

All maintenance resources busy; try again later

If the system technician presses 

HELP

 after entering "test shadow-link" the following 

message will be displayed:

Enter [’long’ or ’short’],

[’repeat’ (1-100) or ’clear’], [’schedule’]

If the command entered is in conflict with another currently executing command, then a 
message will be displayed showing the login id of the conflicting user and the conflicting 
command. The message is as follows:

’login id’:’command’ has a command conflict

If the standby is entering maintenance mode when this command is executed, then the 
following message is displayed:

Cannot interrupt Standby SPE while entering 

maintenance mode; please try later

If the standby SPE is not refreshed when this command is executed, then the following 
message is displayed:

Standby SPE memory not refreshed; 

use the "refresh spe-standby" command.