Polycom DOC2558A ユーザーズマニュアル

The RTM IP card on the rear of the RMX 2000 provides connectivity to all 

the MCU modules. Use the following procedure to replace the RTM IP 

card:
1

Ensure that the power switch on the RMX 2000 is turned OFF (O).

Unscrew the captive screws on the rear panel of the RMX 2000 that 

secure the RTM IP card.

Use the metal ejector levers to pull the RTM IP card out of its slot in 

the backplane.

Carefully slide the RTM IP card out through the rear panel.

On the card to be installed, move the ejector levers to their fully open 

position.

Slide in the replacement RTM IP card.

Push the RTM IP card firmly into the backplane, making sure it is 

properly seated in its slots.

Ensure that the metal ejector levers are fully retracted into their 

housings.

Tighten the captive screws on the rear panel of the RMX 2000 that 

secure the RTM IP card.

10 Turn ON the RMX 2000. 

For more information on the Card Configuration Modes after reset, see "MPM/
MPM+ and MPMx Configuration Modes” on page

.