Patton electronic 29XX ユーザーズマニュアル

Dial Out Locations Window

Access Server Administrators’ Reference Guide 

Restrict Modification (doModemRestrictMods)
Enabling this feature restricts the dialout user from modifying the modem settings. Normally, the dialout user 
has the ability to alter modem operation through the use of AT commands.

•

disable(0)—The user can alter modem operation through the use of AT commands

•

enable(1)—The user is prevented from modifying the modem settings

The first part of the locations window shows each location in the table. There is a status column showing the 
current status of each location. Calls are initiated from this column. The continuous and Dial-On-Demand 
call cycles are stopped from this column as well. To initiate a call, the status is set to “dial(2)” and submitted. To 
remove a location from the table, the status is set to “destroy(7)” and submitted. To stop a dial-on-demand call 
or continuous call from dialing, set the status to “stop(6).”

Figure 45. Location Table

This shows the current status of the location as well as accepts input from the administrator.

•

idle(1)—the location is currently idle, administrator has to set this to dial in order for a call to be initiated.

•

dial(2)—(user selectable) set by the administrator to initiate a call

•

active(3)—when a location is currently in use

•

waitingRedial(4)—for continuous calling, when a location has been disconnected, the location waits in this 
state for 30 seconds before dialing.

•

waitingDemand(5)—for dial-on-demand calling, the location waits in this state until data is preset in which 
case it will initiate a call.

•

stop(6)—(user selectable) set by the administrator to stop continuous or dial-on-demand calling cycle. 
When this is set, no more calls will be placed to this location. Current calls to this location will not be 
affected.

•

destroy(7)—(user selectable) set by the administrator to remove the location from the table.