Alacritech 100x4 ユーザーズマニュアル

2-2 

Alacritech 100 Series Hardware Installation Guide  

The 100x1 Single-Port Server Adapter includes a low profile 
bracket to facilitate installation in a low profile slot. To install a 
100x1 Server Adapter in a low profile PCI slot, the bracket on the 
rear of the card will need to be changed with the included low 
profile bracket.  

1.  Remove the two 4-40 x 3/16 screws bottom side of the 

card.  

2.  Install the low profile PCI bracket - P/N 9012, making 

sure that the mounting tabs are on the bottom side of the 
board and the screws secured from the component (top) 
side. See Figure 3 for details. 

To revert a 100x1 Server Adapter from low profile to standard PCI 
the bracket on the rear of the card will need to be changed to the 
original bracket.  

1.  Remove the two 4-40 x 3/16 screws from the topside of 

the card.  

2.  Install the standard PCI bracket - P/N 6588, making 

sure that the mounting tabs are on the top (component) 
side of the board and the screws secured from the 
bottom side. See Figure 3 for details.