Toshiba Satellite R10 ユーザーズマニュアル

To execute this program, select 2-Repair initial config test in the startup menu, 
press Enter and follow the directions on the screen. The H/W initial information setting tool 
consists of four subtests. Move the highlight bar to the subtest you want to execute and press 
Enter.  

Subtest 01   

Initial configuration 

 

 

 

 

This subtest executes the following items and shows their contents in the display. 
When an item ends normally, the program proceeds automatically to the next one. 
When an error is found, the program stops and waits for key input. (After solving 
the problem, the program executes the item again.) 

 Setting of the CPU set table 
Setting of the microcode 
Setting of the EHSS 
Inputting and writing of DMI information 

 

 

 

 

 

 

When the DMI information is displayed,  

the following messages appear 

in order. Input each information. (If you do not replace the PCB, the DMI 
information should not be changed.) 

1.  “Enter Model Name ?” is displayed. Input the computer’s model name 

and press Enter. (e.g. PORTEGE) 

2.  “Enter Version Number ?” is displayed. Input the computer’s version 

number and press Enter.  (e.g. PC18070C313S) 

3.   “Enter Serial Number ?” is displayed. Input the computer’s serial 

number and press Enter. (e.g. 12345678) 

4.  “Enter Model Number ?” is displayed. Input the computer’s sales model 

number and press Enter. (e.g. PP200-AAAAA) 

5.   “Enter Bundle Number ?” is displayed. Input the computer’s 

PCN/Bundle number and press Enter.  
(e.g. PMSREQ3Q34H/S0123456789) 

6.  “Write data OK (Y/N) ?” is displayed. To write the DMI information to 

the Flash ROM, press Y, and then Enter. 

7.  “Create DMIINFO TXT (Y/N) ?” is displayed. Press Y, then the DMI 

information (text data) is written to the Floppy disk, etc.