Toshiba Satellite R10 ユーザーズマニュアル

This section describes how to determine if the computer’s display is functioning properly.  
Start with Procedure 1 and continue with the other procedures as instructed.   

Procedure 1:  External Monitor Check 

Procedure 2:  Diagnostic Test Program Execution Check 

Procedure 3:  Connector and Cable Check 

Procedure 4:  Replacement Check 

Connect an external monitor to the computer’s external monitor port, and then boot the 
computer.  The computer automatically detects the external monitor.  

If the external monitor works correctly, the internal LCD may be damaged. Go to Procedure 3. 

If the same problem as the internal monitor appears on the external monitor, the system board 
may be damaged. Go to Procedure 2. 

The Display Test program is stored on the Diagnostics disk. Insert the Diagnostics disk in the 
USB floppy disk drive, turn on the computer and run the test. Refer to Chapter 3, Tests and 
Diagnostics for details. 

This program checks the display controller on the system board. If an error is detected, go to 
Procedure 3.