Fujitsu fi-4750C ユーザーズマニュアル
7-13
17. Adjust ADF Erasing Edges
<Screen 57>
1 Press “Next”
or “Previous”
and let the
scanner display Screen 57.
2 At Screen 57, press
or
to select “Yes”
and press
. Then the scanner displays
Screen 57-1.
<Screen 57-1>
3 At Screen 57-1, select “Yes” to return the
settings to the factory default or select “No”
to make new settings (as shown below).
Then press
to make new settings (as shown below).
Then press
. The scanner displays
Screen 57-2.
<Screen 57-2>
4 At Screen 57-2, press
or
to change the
top setting. The value changes in 1 mm
units. Then press
units. Then press
to activate the
setting. The scanner displays Screen 57-3.
<Screen 57-3>
5 At Screen 57-3, press
or
to change the
bottom setting. With (+:Up), the area is set
upward from the bottom edge of the image.
With (–:Down), the area is set downward from
the bottom edge of the image. The value
changes in 1 mm units. Then press
upward from the bottom edge of the image.
With (–:Down), the area is set downward from
the bottom edge of the image. The value
changes in 1 mm units. Then press
to
activate the setting. The scanner displays
Screen 57-4.
Screen 57-4.
<Screen 57-4>
6 At Screen 57-4, press
or
to change the
left setting. The value changes in 1 mm
units. Then press
units. Then press
to activate the
setting. The scanner displays Screen 57-5.
<Screen 57-5>
7 At Screen 57-5, press
or
to change the
top setting. The value changes in 1 mm
units. Then press
units. Then press
to activate the
setting. The scanner displays the next setup
item.
item.