Intermec SR60 ユーザーズマニュアル
Chapter 5 — Configuring General Features
140
SR60 Scanner Programmer’s Reference Manual
Configuring the Low Power Mode
When enabled, Low Power mode causes the scanner to power
down completely between trigger pulls. This results in very low
idle current, lowering the energy needs of the scanner. However,
the microcontroller must reboot with every trigger pull, which
causes a very small delay in scanning. Intermec recommends that
you use this mode only when the scanner is connected to a
battery-powered terminal.
down completely between trigger pulls. This results in very low
idle current, lowering the energy needs of the scanner. However,
the microcontroller must reboot with every trigger pull, which
causes a very small delay in scanning. Intermec recommends that
you use this mode only when the scanner is connected to a
battery-powered terminal.
To enable or disable the Low Power mode
1
Scan the SET bar code.
2
Scan the both the Step #1 and Step #2 bar codes to enable or
disable the option.
disable the option.
3
Scan the END bar code.
1.5 Seconds
---------
END ------------------------------------------
Note: This feature is not affected when you restore the factory
defaults by scanning the Return to Factory Defaults
programming bar code. You must manually enable or disable this
feature.
defaults by scanning the Return to Factory Defaults
programming bar code. You must manually enable or disable this
feature.
SET ------------------------------------------
Enable Step #1
---------