Motorola LS7708 ユーザーズマニュアル

4-3

The scanner can be programmed to perform various functions or activate different features. This chapter describes each user 
preference feature and provides the programming bar codes necessary for selecting these features for the scanner. Before 
programming, follow the instructions in 

.

The scanner is shipped with the settings shown in the 

 (also see 

 for all host device and miscellaneous scanner defaults).

To set feature values scan single bar codes or short bar code sequences. The settings are stored in non-volatile memory and are 
preserved even when the scanner is powered down. Scanning parameter setting bar codes with the primary scanner also changes 
settings on the auxiliary scanner.

If not using a Synapse or USB cable, select a host type (see the host chapter) after the power-up beeps. This only needs to be done 
once upon the first power-up when connected to a new host.

To return all features to their default values, scan the 

 bar code on page 4-5. Throughout the programming bar code 

menus, asterisks (

) indicate default values.

In most cases scanning only one bar code sets a specific parameter value. For example, to set the beeper tone to high, scan the High 
Frequency (beeper tone) bar code listed under 

. The scanner issues a short high beep and the LED turns green, 

signifying a successful parameter entry.

Other parameters, such as Serial Response Time-Out or setting Data Transmission Formats, require scanning several bar codes. Refer 
to 

 and 

 for descriptions of this procedure.

Unless otherwise specified, if an error occurs during a scanning sequence, just re-scan the correct parameter.

 lists the defaults for user preferences parameters. To change any option, scan the appropriate bar code(s) beginning in 

.

Refer to 

 for all user preferences, hosts, symbologies, and 

miscellaneous default parameters.

Feature/Option

*

 Indicates Default

Note