Motorola MSXX04 ユーザーズマニュアル

Installation

2 - 5

You can attach the base of the scanner’s stand to a flat surface using two screws or double-sided tape (not 
provided).

Position the assembled base on a flat surface.

Screw one #10 wood screw into each screw-mount hole until the base of the stand is secure.

Peel the paper liner off one side of each piece of tape and place the sticky surface over each of the three 
rectangular tape areas.

Peel the paper liner off the exposed sides of each piece of tape and press the stand on a flat surface until it is 
secure.

The optional mounting bracket kit consists of a scanner bracket, a mounting bracket, and the hardware required to 
mount the scanner. The bracket kit accommodates adjustable angles for optimal positioning of the scanner.

To mount the MiniScan scanner on the bracket, first secure the scanner to the scanner bracket, then attach the 
mounting bracket to the wall (see 

Tilt the scanner bracket forward to access the center scanner mounting hole on the bracket.

Place the bottom of the scanner on the scanner bracket, aligning the scanner’s center threaded insert (beneath 
the scan window) with the center mounting hole on the scanner bracket.

Insert one of the screws provided through the mounting hole and into the scanner’s center threaded insert. 

For the Symbol MS1204FZY, MS2204, and MS2204VHD, use a #0 Phillips screwdriver; for the Symbol 
MS3204, use a #1 Phillips screwdriver.

Two screw-mount holes

Double-sided tape 
areas (3 places)
(dimensions = 1” x 2”) 

The mounting bracket is optional for the Symbol MS1204FZY, MS2204, MS2204VHD, and MS3204 only.