Motorola DS6707 ユーザーズマニュアル
Chapter 10 Symbologies
Introduction
This chapter describes symbology features and provides programming bar codes for selecting these features.
Before programming, follow the instructions in
Before programming, follow the instructions in
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when you power down the digital imager scanner.
memory and are preserved even when you power down the digital imager scanner.
Select a host type (see each host chapter for specific host information) after the power-up beeps sound. This is
only necessary upon the first power-up when connecting to a new host.
only necessary upon the first power-up when connecting to a new host.
To return all features to default values, scan the
. Throughout the programming
bar code menus, asterisks (
*
) indicate default values.
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to transmit bar code data without the
UPC-A check digit, simply scan the Do Not Transmit UPC-A Check Digit bar code under
UPC-A check digit, simply scan the Do Not Transmit UPC-A Check Digit bar code under
. The digital imager scanner issues a fast warble beep and the LED turns green, signifying a
successful parameter entry.
Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes. See the individual
parameter, such as Set Length(s) for D 2 of 5, for this procedure.
parameter, such as Set Length(s) for D 2 of 5, for this procedure.
NOTE
Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
*
Enable UPC-A
(01h)
Feature/Option
*
Indicates Default
Option Hex Value for
programming via SSI command
programming via SSI command